Contact Us

Use the form on the right to contact us. 

You can also email us at lramos@unitedenergycorp.net or call us at (732) 994-5225 

3526 US Hwy 9 South - Ste. 303
Howell, NJ 07731
United States

CR-1 Corrosion Remover

CR-1 CORROSION REMOVING
AND
METAL CONDITIONING COMPOUND TYPE I

This product is a concentrated corrosion removing and metal conditioning product, which when diluted with water and applied to metal surfaces, will remove rust from ferrous metal surfaces and provide a slight etching action to promote the adhesion of paint or corrosion preventatives. It may also be used in immersion tanks for highly corroded small and large parts. It is also effective for removal of light grease and oils, to reduce preparation time prior to further treatment.

Directions for use

For use as a wash off product:

Add one part of concentrated material to three parts of water by volume. Use polyethylene or acid resistant containers to mix. Remove heavy rust by wire brush and heavy grease with a grease solvent before applying the compound. On rusted surfaces apply by spray, dip or brush-on. Allow material to remain long enough to loosen the rust (from two to ten minutes). Rinse surface with warm or hot water. Permit it to dry thoroughly before applying rust preventative or paint.

For use in immersion tank:

Add one part of product to three parts of water. Remove heavy rust by wire brush and heavy grease with solvent or alkali bath before immersion. After soaking, rinse with water or alkali solution. Permit to dry completely before application of rust preventative or paint. May be used from room temperature or at temperatures not to exceed 140oF.

Properties

Specific Gravity: 1.11
Density: 9.3 Lbs. / Gal.
Appearance: Clear Light Yellow Liquid
pH: 1.0
Boiling Point: >212oF
Odor: Glycol Ether
Solubility in Water: Complete
Freezing Point: 32°F


FOR INDUSTRIAL USE ONLY
EXERCISE SAFETY PRECAUTIONS- REFER TO MSDS